COMBIMATE Combiphos Refill

Product Information

Scale Prevention – These prevent these chemicals depositing themselves inside pipes, tanks and shower heads. These are small plumbed-in devices that use chemical, electrolytic or magnetic methods to accomplish this. Combimate which is a hard water scale inhibitor is in this group. Combimate requires very little space (roughly about the size of a teapot) and can be installed virtually anywhere on a home’s cold water supply pipework on either 15mm or 22mm pipework. Limescale doesn’t just form on taps and shower heads. Limescale can form on any surface where water is heated, including the internal surfaces of pipework and boilers. Below is a list of places where your home is vulnerable to the damaging effects of limescale formation: Easy to install: The refill is easy to install, and it comes with clear instructions to help you get started

No. Combimate is not a water softener; water softeners generally use salts so softened water requires a separate supply because of the increased salt content. There are two installations options when fitting Combimate: whole-house supply or single appliance protection. Combimate is a widely recognised, provenhard water scale inhibitorthat since its launch in 1987 has delivered protection to hundreds of thousands of homes.

You are using an out of date web browser

Water Softeners – A water softener is a larger electrical /mechanical device which removes the chemicals in hard water areas which cause scaling: calcium and magnesium carbonate. These devices turn hard water to soft water. In a central heating system, Combimate will only protect the boiler via the mains water feed into the heat exchanger. However, the ‘closed loop’ of the heating system (radiators, pipework etc) is not protected. Combiphos coats the inside of the pipework, boiler heat exchanger and appliances with a non-residual, microscopic, protective coating to prevent scale-causing minerals from accumulating and aggressive soft water from corroding the system and appliances.

Combimate is a user-friendly domestic limescale prevention device that uses Combiphos to deliver guaranteed prevention of limescale and soft water corrosion water control, with no moving parts. Tried and tested– Combiphos is a polyphosphate compound specifically developed to provide the most effective limescale prevention in flow-through installations. Polyphophate dosing has been safely used to treat water throughout the world for many years. Safe to use: The Cistermiser Combiphos Refill is safe to use and does not pose any health risks to users when handled correctly This reinforces our statement of Sustainability without Compromise, ensuring that we practice what we preach whilst consistently providing our customers with fantastic service.Whole-house supply– For this installation Combimate should be plumbed in after the stop-valve on the cold water supply to the premises. The white removable divider tray should be removed from inside the Combimate dome in a whole house installation so that the dome can be completely filled with Combiphos (the full 800g bag contents). Combiphos is 100% food grade material approved by the FAO/WHO and compliant with the European normative standard BS EN 1208, that prevents scale build-up and soft water corrosion in combination boilers and other domestic hot water appliances.

Fitting is simple – the only plumbing required is to route and connect two pipes, plus fixing the unit to the wall. This job can take less than one hour. Yes. If the Combimate is located in a warm environment (e.g an airing cupboard) or near a heat source, the Combiphos crystals will dissolve at a faster rate. Ideally Combimate should be installed at room temperature with a cold water supply, located at least 450mm from any appliance or local heat source to prevent water in the dome from warming and accelerating the dissolution of the Combiphos. Note: Combiphos does not soften water and its effectiveness may be reduced in water heated to temperatures above 60 degrees, in water with carbonate hardness levels above 360 ppm or at pH levels below 6.5. Function: This product is designed to refill the Cistermiser Combiphos water treatment system. It is a phosphate-based compound that helps to prevent the buildup of limescale and corrosion in hot water systems Combiphos coats the inside of the pipework, boiler heat exchanger, and appliances with a non-residual, microscopic, protective coating to prevent scale–causing minerals from accumulating and aggressive soft water from corroding the system and appliances.

You may also like

This action prevents scale formation while retaining the health benefits of the natural minerals contained in hard water. Installation of the Combimate has been carried out in accordance with the manufacturer’s instructions. We ask you to return the goods in their original condition securely wrapped. You must also pay the postage for returning the goods.

Health and safety– Combiphos is tasteless and odourless and contains a polyphosphate compound which is classified by the WHO as a ‘food-grade’ additive. The quantity, size and hardness of the spheres control the amount of Combiphos released. Typically this is less than 3 ppm (parts per million) of phosphate in treated water and perfectly safe for human consumption. Your Combimate can be installed to offer two levels of protection – the whole hot water system or a single appliance.High-quality: Cistermiser is a well-known brand in the water treatment industry, and the Combiphos Refill is made from high-quality materials that are designed to last