Alien Abduction Lamp The Original UFO Flying Saucer LED Night Light

Product Information

There is a light bulb inside the UFO top which illuminates the windows and glass beam creating a wonderful effect. Secondly, the circle of grass under the saucer (see right) looked much too small, so I cut a bigger one. The cow is removable and can be replaced with anything that fits within the tractor beam which is 15cm tall with a 13cm diameter at the bottom, thinning to 4. The Funky Company lamp is now sold out, but for more lighting ideas you can see Bored Panda’s creative lamp designs.

I used a low-wattage soldering iron to de-solder the switch from the board, and then soldered lead wires to the appropriate spots on the printed circuit. have a cult following and are hugely popular showing the appetite for extra-terrestrial beings is huge. In addition to the beaming-up Bessie, the table lamp's flying saucer also sports glow-in-the-dark little green men heads with bulbous eyes peeking out of each of its windows.

You can change your choices at any time by visiting Cookie preferences, as described in the Cookie notice. Etsy’s 100% renewable electricity commitment includes the electricity used by the data centres that host Etsy. The two unattached lower wires with their brass connectors will be attached to the contact pins on the push-button switch mounted in the bowl.

I used a circle template to carefully plot the positions of both sets of holes to make sure there was room for them, and that they didn't interfere with each other. So I drilled the three small reflector mounting holes again, and the three small plate mounting holes again, and very carefully, and very slowly used the circle cutter to cut the larger hole in the middle until .No press-on leads were available in such small sizes, so I fabricated a couple out of sheet brass, and soldered them to the ends of the switch leads coming from the LED PCB.

After everything was done, I found a farm set that had a cow in it at Target’s dollar spot, so I had to get it to make the lamp perfect! When the glue was thoroughly dry, I made a small hole in the middle of the piece of "grass", slipped the sprue into the hole from the bottom, pressed the cow onto the top of the piece of sprue, and Voila!

com/listings/UFO-Alien-Abduction-Lamp-Bedroom-RED-Spaceship-Night-Light-Office-Desk-Custom/405823551?